A play with macramé

On pinterest I seem to have a rather large collection of pictures of plants, and have seen lots of these lovely string plant hangers.

Most of my house plants sit together on a little table in the corner of our sitting room, but I’ve long been thinking it might be good to suspend a couple of them to add a bit of dimension to that area.

I wasn’t really sure where to start with the macramé – it looked quite complicated, but actually was really super easy, and after watching some youtube videos, I was feeling rearing to go! (I hope this description of what I did has the same effect on you and doesn’t put you off!) I warn you, I did go off in my own direction a bit….

I used some twine I had and some white knitting cotton I added in to make it a bit more robust. And found some wooden beads left over from my crochet beads which I thought would look nice with this natural colour scheme.

To start with measure out 4 lengths 4 metres long. Lay the lengths together, fold them in half and tie a loop in the top (so you are left with 8 lengths each 2 metres long)

I hooked my loop over a door handle and seperated the pieces. It was a bit confusing at first because I was using two different threads together, but had to remember that I was working with 8 (double) lengths and not 16. If you don’t use double thread though and use cording or something similar you won’t have this confusion to worry about.

DSC04914making a macramé plant hanger

Start by knotting two lengths together all the way around (4 knots) 20cm from the top knot. (There are a lot of different macramé knots to try, but I kept it very simple using a basic overhand knot throughout)

Next measure 10cm down and you want to seperate your two strands and tie one of these to one of the strands from the neighbouring pair. The strand that is left from that pair you want to tie to one strand from the next pair round. Repeat this all the way round. (make sure you always pair up with the neighbour – I did get in a bit of a muddle at one point and had to unknot!)

DSC04925DSC04927

At this point I added a bead to each knot by threading them onto one of the twine threads and knotting below the bead to secure it.

easter cactus in my macrame plant hanger

The next knots are another 20cm down (always seperating and knotting with the neighbour) with some more beads attached, then the next 10cm with beads, then another set 10cm with beads and finally some more knots another 10cm without beads. Lastly I tied all the strands together in one big knot 10cm from here to make a tassel. (I trimmed the ends and tied some more beads on for fun)

DSC04939

I definitely want to make another one of these and will change my pattern a bit as realised that the top sets of knots hang tightly together so perhaps were not really needed, although do add a bit of interest, but could have been replaced with a plait or more beading or something like this. It was a bit of trial and error with the spacing of the knots and I think this will be fun to experiment with a little bit.

DSC04945

Maybe have a go and report back for me!?